Description This article describes techniques on how to identify, debug, and troubleshoot issues...
FortiSwitch
gg9
New Contributor
Created on
Edited on
I have a FortiGate 50E, unlisense, firmware v5.4.1When try setup 2 vlan, vlan10 ip 192.168.10.1/24vlan20 ip 192.168.20.1/24if I enable DHCP on VLan then it wont give ip to any PC but DHCP on port still workAnd no matter ...
d3xmeister1
New Contributor II
Created on
Hi, the title says it al, how to block internet except one (or two) address (or IP) without using web filtering. We don't want to make a rule to enable internet then filter, that's something our auditor does not allow, s...
ryanswj
New Contributor
Created on
Edited on
Hi, I am running FortiOS 7.4.7 on a FortiGate-60F and am trying to migrate from SSLVPN to IPsec VPN. I've managed to configure IPsec (IKEv2) dial-up to work fine, but I notice that when I set the mode to IPSec over TCP, ...
Simo94
New Contributor
Created on
Edited on
hi Team, HA : A-Pmodels : 901G so I connect to the mgmt interface of the fortigate with RJ45 to setup the cluster. everything is going fine I setup the member that I'm connected to to be the primary. after the cluster is...
buk
Visitor
Created on
Edited on
Very simple vpn set up for my iPhone. I have a Fortigate 40F firewall. I'm able to access my movie server after successfully connecting to the vpn but not the hikvision cameras that I have configured on the Hik-Connect a...
pacionet
New Contributor
Created on
We have a network topology like below. If we put a traffic shaper of 50 Mbps on Fortigate (Central Site) to limit some traffic (windows update) on site 1 and site 2 and site 1, for examples, in some moments, produces mor...
thaootix
New Contributor
Created on
Abstract:This study examines the impact of manual threat intelligence updates on system memory consumption in Fortigate 60E and 60F firewall models following USOM integration. Test results indicate that after performing ...
d3xmeister1
New Contributor II
Created on
Hi, I have 2 computers in 2 separate VLAN's, and I need to make them see each other. There are many other computers in both VLAN's but I only want these 2 specific computers to talk with each other. I made Addresses for ...
Can't find what you are looking for?
Suggest New Article