Fortinet Community

vjoshi_FTNT · 03-15-2021

DescriptionThis article describes how to enable logging on FortiController and configure it to send logs to syslog server or a FortiAnalyzer(with syslog ADOM).SolutionSettings required On FortiAnalyzer.- Enable ADOM on FortiAnalyzer (skip this step i...

vjoshi_FTNT · 10-23-2018

DescriptionThis article describes how to reset the password on FortiMail in HA(config-only) ScopeApplies to FortiMail HA in 'config-only' modeSolutionExample: FortiMail HA with 4 devices in config-only mode and the admin password is lost.steps by ste...

vjoshi_FTNT · 10-23-2018

DescriptionThis article explains about how to reset the password of FortiMail (V5.3.0GA and below). Scope Note- The password reset with maintainer only works on V5.3.0 and below.- V5.3.1GA and later, 'maintainer' option is removed for to improve the ...

vjoshi_FTNT · 02-23-2017

DescriptionThis article explains how to create a custom signature to block files according to the hash value of the file.SolutionIn this example, a custom signature will be created that allows a hash value (or checksum) to be specified of a file that...

vjoshi_FTNT · 11-24-2016

Description This article explains how to abort an ongoing VA Scan. This is important in cases where the VA scan is causing high resource utilization, or if a scan needs to be stopped for any other reason Solution Go to Vulnerability Assessment -> Ass...

vjoshi_FTNT · 03-22-2017

Hello Jacky, Welcome to the Fortinet Forum. I am not sure what exactly the PCI report is referring to. However, on the Fortigate, both the UDP idle timer and ICMP ttl are different from the session-ttl. For UDP, below takes effect:config sys global s...

vjoshi_FTNT · 01-29-2017

Hi,Yes, you can use any interface for the HA heartbeat. And even combine different interfaces for the LACP.- When you add the LACP, it shows the list of interfaces which can be added.Important thing is to make sure that the speed of the interfaces wh...

vjoshi_FTNT · 01-29-2017

1) Is this ok to leave as the "Action=Accept" for "Service=All" for the policy if the "Destination=VIP"? Would the logs still show traffic getting dropped if someone tries to access the public IP on a port that is not getting forwarded via the VIP? Y...

vjoshi_FTNT · 09-25-2016

Hello Emil, I haven't tried this in a production setup, however, logically, it shouldn't impact the traffic if configured properly. You enable the secondary vcluster and the production vdoms should be configured to have the current master as master a...

vjoshi_FTNT · 09-25-2016

Hello Dotix, Could you please attach the config file?  

Fortinet Community

User Statistics

User Activity

Technical Tip: Logging on FortiController

Technical Note: How to reset the password on FortiMail in HA(config-only) without rebooting all the devices in cluster

Technical Tip : How to reset the admin password on FortiMail using 'maintainer'

Technical Note: How to block files based on the hash value

Technical Tip: How to abort a running VA Scan on FortiDB

Re: Setting ICMP/UDP Virtual Session Timeout

Re: Upgrade: Fortigate 311B => Fortigate 201E

Re: Port Forwarding &Port Address Translation

Re: Enabling vCluster2

Re: Policy routing and Rule Based Routing

Technical Tip: Use of Black hole route in site to ...

Re: Enabling vCluster2

Re: 600C recurring crash

Re: How to schedule a weekly (not daily) reboot?

Re: Fortigate firewall intermittently blocking tra...

Re: Fortigate firewall intermittently blocking tra...

KCS

Fortinet Training Institute