Description This article describes how to configure MESH with FortiAP on
FortiGate. Scope FortiAP, FortiAPU, FortiAPS, FortiAP-W2 (6.2.2 and
above). Solution - Creating the mesh root SSID. 1) Go to WiFi and Switch
Controller -> SSIDs and select Creat...
DescriptionThis article describes how to check the correct region code
on FortiAP based on the country.Solution1) Take CLI access and check the
FortiAP region code using the command:ap# fap-get-statusVersion:
FortiAP-421E v6.4,build0437,200806 (GA)Se...
DescriptionThis article describes how to change image on FortiAP-U
models from Meru to Fortinet while the FortiAPis online on
FortiWLC.ScopeFor FortiAP-U models only.Solution1) Take CLIaccess to the
FortiWLC.2) Connect into the FortiAP using the belo...
DescriptionThis article describes how to set password on FAP when
deploying on FortiAP Cloud.SolutionThere are 2 ways to set the FortiAP
Password when FortiAP is connected on FortiAP Cloud.During the time of
deployment:- Open the FortiAp Cloud portal...
DescriptionThis article describes how to run FortiAp shell commands via
FortiGate CAPWAP tunnel.SolutionIt is very often that the FortiAp in the
field is behind a NAT unit, and access to the FortiAP through telnet or
SSH is not available. It will be ...
Hi REDSCT, You can use any radio for the mesh setup, Only thing to make
sure is both ap's are able to see each other. Thanks for highlighting
the missed detail: I have corrected that now. it should be like below:
cfg -a MESH_AP_TYPE=1 cfg -a MESH_AP_...