Description This article describes how to resolve packet loss issues in
the SD-WAN overlay network. Scope FortiGate, SD-WAN. Solution Consider a
scenario where an administrator deploys an SD-WAN overlay with Remote
internet access (RIA) for the branc...
Description This article describes how to work around an issue where web
connections are not blocked as intended, and explains how to effectively
block the established web connections when switching from different
networks to FortiGate affiliated net...
Description This article describes the required tools for restoring
firmware and configuration to numerous Fortinet products after an RMA.
Scope FortiGate, FortiMail, FortiSandbox, FortiSwitch. Solution Below
are the tools required for this operation...
Description This article describes how to avoid a duplicate ARP (Address
Resolution Protocol) conflict observed in a NAT mode VDOM when connected
with a transparent mode VDOM. Scope FortiGate, VDOMs in transparent
mode. Solution When different VDOM m...
Description This article describes how to create and append addresses
into address groups through automation stitches. Scope Any supported
version of FortiGate. Solution This article explains how to create an
automation stitch that takes an action to...
Hello cms8000, Thank you for using the Community Forum. I will seek to
get you an answer or help. We will reply to this thread with an update
as soon as possible. Thanks,
Hi Tom, In the absence of other information about your setup, all we can
suggest is the main difference between using FortiZTP with FortiManager
Cloud as opposed to any other kind of FortiZTP-FortiManager setup: The
"Automatically link device" option...
Hello Tom, I'm sorry we haven't been able to get you an answer yet.
FortiZTP has relatively few experts. I am still looking. For the moment,
I recommend you check out the documentation here
https://docs.fortinet.com/product/fortiztp if you haven't
al...
Hello again R_F, I talked with one of our experts. It sounds like this
is what you are trying to achieve: User - > FSS -> SPA HUB -> [SDWAN]
Internet. However, it would be more efficient to configure the
following: User -> FSS -> Internet From what I...