Description This article describes debugging steps for a '500 Internal
Server Error' displayed on the FortiSwitch GUI after upgrading it to
FortiSwitch OS 7.4.7. Scope FortiSwitch models below: FS-108E,
FS-108E-POE, FS-108E-FPOE, FS-124E, FS-124E-POE...
Description This article describes the FortiLink topologies supported by
Fortinet and some notes on what to expect when enabling or disabling
'fortilink-split-interface' on the FortiLink interface. Scope FortiOS
7.2 and upwards.FortiSwitch OS 7.2 and...
Description This article describes how to add more MAC addresses when
using Address group policy authentication after the maximum number of
MAC addresses has been reached by FortiGate. Scope FortiAP MAC address
authentication. FortiOS any version. So...
Description This article describes the steps to recover the service on a
FortiSwitch, showing several errors even after rebooting it. Scope
FortiSwitch OS. Solution FortiSwitch shows the following logs over and
over when connected via console port: 1...
Description This article describes the commands to upload FortiSwitch
images to FortiGate for firmware staging. This step was omitted on
Upgrading MCLAG peer group switches from FortiSwitchOS 7.4.2 and earlier
to FortiSwitchOS 7.4.3 and later and Upg...
Excellent post. I was trying to block a VPN (NordVPN) that some clients
were using on their phones to workaround the web filter I had
configured. After following the instructions from this post, issue
resolved. Thanks a lot!
Hard question to answer. Let me try to summarize as best as I can.
Depending on the client's spatial streams, SNR, channel width and WiFi
amendment one wireless client can reach up to 2402Mbps PHY on 5GHz
(802.11ax). For that to occur, 1024-QAM modul...