Description This article describes the constraints and requirements
related to MAB in FortiSwitch. Scope All FortiSwitch models. Solution
MAB is used for devices that do not support 802.1X authentication. If
you enable the MAB option on the port, the...
DescriptionThis article describes how to change FortiSwitch interface
mac-addresses by using the following instructions.SolutionLogin into the
switch interface and change the mac-address of the required
interface.FSW # config system interfaceFSW (int...
Description This article describes how to use Remote sampling on
FortiSwitch to capture packets specific to port, Mac-addresses or IP.
Scope For FortiSwitch managed by FortiGate.Solution In the below
example, all traffic is sent on Port 1 to destinat...
DescriptionThis article describes how to enable logs for specific
filters.Solution1) Generally, logs can be viewed from from FortiSwitch
using '# execute log display'.FSW # execute log display596 logs found. 1
logs returned.1: 2020-12-16 18:01:42 log...
DescriptionIn some rare scenarios, if FortiSwitch upgrade fails via GUI
and CLI, upgrade the via boot sequence is possible.This article
describes how to upgrade a FortiSwitch via the boot sequence.Solution1)
Plug in the console cable to the Fortiswit...
Dear @blake09 Hope you are doing well. Normally for a managed
fortiswitch, when any vlan is created under "Fortiswitch vlan" section,
it will get pushed to the switch. In managed Fortiswitch scenario , the
switches act as layer-2 , while the gateway ...
Dear @OmarMuhumayev Hope you are doing well. Can you please ensure the
following LLDP med voice profile/config is configured correctly on the
fortiswitch port . Referenced Article :
https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/939493/v...
Dear @nrahman Yes with switches more than two switches, we can have
first two core switches directly plugged into the FSW . Configure
stacking b/w them (mclag-icl) and connect end switches on the core .
Example architecture : Multi-tiered MCLAG with ...
Dear @nrahman It depends on how many and the model of switches . I would
recommend an "mclag-icl" setup per the topology guide(supported for 1xx
series above) :
https://docs.fortinet.com/document/fortiswitch/6.4.2/devices-managed-by-fortios/617516/ne...