Technical Tip: How To Properly Configure VRRP For ...

jcamacho1 · 05-28-2025

Description This article describes how to configure VRRP in a situation where it is necessary to apply the parameter over a secondary IP address. Scope FortiSwitch v7.2.10, 7.4.6, 7.6.2 and above. Solution When VRRP is required for a secondary IP add...

jcamacho1 · 04-14-2017

DescriptionThe FortiWAN configuration file is encrypted and the information that it contains cannot be seen in a simple text editor.ScopeAny FortiWAN device at any firmware version.SolutionThe configuration file information can be obtained from the G...

jcamacho1 · 04-14-2017

DescriptionFrom version 3.5.0 it is possible to split 40G ports into four 10G ports on following devices:FS-3032D (Port5 to port28 can be split)FS-524D, FS-524D-FPOE (Port29 and port30 can be split)FS-548D, FS-548D-FPOE (Port53 and port54 can be spli...

jcamacho1 · 04-14-2017

Description This article describes steps which can be taken to confirm the root of the issue that has brought the ADSL service status down in the event of an ADSL connectivity failure.One possible cause is an actual physical failure that sometimes ca...

jcamacho1 · 01-11-2017

Description This article describes how to resolve the L4 load balance no connectivity issue on FortiADC. Scope FortiADC.Solution The 'DNAT packet forwarding method' only considers destination IP address translation, keeping the source IP address in t...

jcamacho1 · 08-22-2024

Thank you for this article!!   Best regards. Jonathan C.

jcamacho1 · 05-27-2021

Thank you.

jcamacho1 · 05-24-2021

Hello,I was not able to finish the lab (it never full\y load actually). Is it possible to count with access to the lab one more time?Thank you for your attention.Best Regards.

User Statistics

User Activity