Skip to main content
MrAitch
MrAitch
New Member
January 28, 2020
Question

Lost access

  • January 28, 2020
  • 1 reply
  • 5514 views

Hello

 

I tried to configure a 200E to un in transparent mode tonight.

 

I set the internal IP, netmask and gateway. Through CLI.

 

Now I can't access the set IP, ping the device or access through the management port.

 

I'm basically trying to stick it in transparent for a few weeks while the new tech guy gets here. Not sure what has gone wrong. I have tried adding it to the main router, but still not seen. I do have a backup of the config. Is there a way to restor via the USB or do a reset on it. The previous usergroups etc on there were from the previous set up and were not being used.

 

 

    1 reply

    ede_pfau
    SuperUser
    ede_pfau
    SuperUser
    January 28, 2020

    I hope that the management IP you assigned was from your local LAN. In this case, the FGT doesn't need the default route (gateway). If you are sure about the IP you've assigned, connect with a notebook which has an IP from the same subnet and you should get access.

    Then, have a look at the default route.

    MrAitch
    MrAitchAuthor
    New Member
    January 28, 2020
    I managed to ping it while connected to mgmnt and it responsed. I still can't access it.
    Terms & ConditionsAccessibility statement