Forti Setup Message

7 replies
6639 views

Hello,

I had Virtual Fortigate in Azure VM02, Version was 7.2.5

Then I did upgrade up to 7.4.0 and now see this message:

And I can't disable. Even if I'm trying to click "Begin" I can't do any migration, but If I click "Later" Fortigate is working as normal.

Very annoying message, how I can disable it?

FortiGate

1mmAnswer

Explorer III

Hello,

There was License issue after upgrade... I just re-apply license and after that I did as @abarushka said - hit toggle "Don't show again" pop-up message "Migrate config with forticonverter message" will not appear.

abarushka

Staff

Hello,

It should be possible to disable notification message. Please find the instructions by following the link below:

https://community.fortinet.com/t5/FortiGate/Technical-Tip-Firmware-upgrade-notifications/ta-p/193669

1mmAuthor

Explorer III

Hello @abarushka, Thanks for your reply,

Tried, but still the same... :(

abarushka

Staff

Hello,

I checked in the lab. In case you hit toggle "Don't show again" pop-up message "Migrate config with forticonverter message" will not appear. Please find an attached file.

forticonverter.JPG

1mmAuthor

Explorer III

@abarushka

I can't find "Don't show again" toggle:

Even if I click "begin":

1mmAuthorAnswer

Explorer III

Hello,

There was License issue after upgrade... I just re-apply license and after that I did as @abarushka said - hit toggle "Don't show again" pop-up message "Migrate config with forticonverter message" will not appear.