Skip to main content
DanielChernovsky
Visitor III
May 4, 2022 6:52 AM UTC
Question

FortiManager and forward-error-correction

Hello all,

 

Following an upgrade of the Fortimanager and the FortiGate to 7.0.3 (from 6.4.6), we are encountering an issue with installing policy and configuration from the Fortimanager.

 

The problem is that after the upgrade, a line was added to several interface port (part of aggregation link) configurations (set forward error correction disabled), and when trying to push configuration and policy, the Fortimanager removes this line, and the port becomes unavailable.

On the Fortimanager CLI configuration of this device, the feature is disabled, and this change is not showing on the change revision during the installation.

 

After each install, I need to connect to the FortiGate and add "set forward error correction disabled" to both of the ports, and the comm restores.

 

Please advice 

 

2 replies

Esteemed Contributor III
May 6, 2022 5:32 PM UTC

Hi @DanielChernovsky ,

 

Thank you for using the Community Forum. I will seek to get you an answer or help. We will reply to this thread with an update as soon as possible. 

 

Thanks, 

Translate
Esteemed Contributor III
May 11, 2022 12:22 PM UTC

Hello @DanielChernovsky ,

 

While researching your query, we figured out that the 'FortiManager should not unset the value forward-error-correction with certain FortiGate platforms'. It could be the case that you are facing the known issue mentioned on the link below.

 

Reference: https://community.fortinet.com/t5/FortiGate/Technical-Tip-Forward-Error-Correction-FEC/ta-p/195247


Let me know if this helps.

 

Thanks

Translate
Risk and Resilience in the Age of AI. An OT Thought Leadership Summit for Houston's Critical Infrastructure Leaders. Date: Thursday, December 3, 2026. Time: 8:30 am - 1:30 pm (CT). Location: The Westin Houston, Memorial City | 945 Gessner Road, Houston, TX 77024