VXLAN

Forum|Forum|5 years ago
November 11, 2020
4 replies
5416 views

Hi, just after some help from anyone who has had some experience with VXLAN.

I setup a VXLAN a while ago which worked fine but now has stopped passing traffic? the ipsec tunnel is up but can only see traffic either side, ie not traversing the L2 VXLAN, it's a fairly simple setup, diag attached

Any help/suggestions appreciated.

Dave

FG VXLAN Config.jpg

Best answer by dtonkin

Hi resolved this VXLAN issue by using set intra-switch-policy implicit in the vxlan softswitch config.

emnoc

New Member

The cli cmd diag debug flow is your friend. I would run that and also diag sniffer packet the interface to see if packest are being sent or recv Also review closely your diag vpn tunnel list details to see if encryt/decrypt is happening and you have a valid SPI in/out.

Ken Felix