Skip to main content
abdurn
abdurn
New Member
October 25, 2015
Question

switch mode to interface mode

  • October 25, 2015
  • 2 replies
  • 27497 views

i try to change switch mode to interface mode from on virtual appliance i try in first step after install it directly i did after assign IP and before the command was

config system global

set internal-switch-mode interface

 

the error was

command parse error before 'internal-switch-mode'

command fail. return code -61

    2 replies

    Joshua_MJ
    Joshua_MJ
    New Member
    October 26, 2015

    Hi, firstly make sure that there is no any firewall policy that is associated with the lan/switch

    abdurn
    abdurnAuthor
    New Member
    October 26, 2015

    yes there is no any policy its fresh install virtual appliance but after install i found default deny policy and its never allow to delete

    rwpatterson
    rwpatterson
    New Member
    October 26, 2015

    Also remove any references to DHCP scopes and routes.

    abdurn
    abdurnAuthor
    New Member
    October 26, 2015

    im do fresh install a virtual applaince only one default policy exist and cannot delete

     

    Terms & ConditionsAccessibility statement