Skip to main content
Gypsy_Dave
Gypsy_Dave
New Member
November 8, 2021
Question

Static route problems

  • November 8, 2021
  • 1 reply
  • 2057 views

Hi guys,

I have a FG 30E and I've setup a static route to a Cisco 2600 router which is routing between token ring and ethernet on different subnets. 

 

The Cisco 2600 router has its ethernet NIC configured as 192.168.1.101 and the token-ring NIC as 192.168.2.1 There is one device on the token ring network which has be assigned the ip 192.168.2.11 from the DHCP helper on the 2600. On the 2600 router I can ping both the 192.168.2.11 client and the 192.168.2.1 gateway (Token ring NIC). 

 

On my FG network (192.168.1.0/24) I can ping the 2600 router gateway 192.168.2.1 but I can't ping 192.168.2.11 (the client on the token ring network) 

 

Any ideas why on the Cisco 2600 router I can ping the client (192.168.2.11) and via the FG or main LAN  I can't? My FG static route has the entire subnet included. 192.168.2.0/24 255.255.255.0

    1 reply

    Julien87
    Julien87
    Contributor II
    November 9, 2021

    Hi Dave,

     

    Have you try to install wireshark on client 192.168.2.11 to check if icmp packet is received ?

    If it's received and send echo packet, you can check the gateway in the device client.

    You can do a diag sniffer packet in the fortigate to check if you see this packet.

     

    The other think, is a device client firewall  ?

     

    Best regards,

     

    Julien

    Terms & ConditionsAccessibility statement