Skip to main content
jasetcs
jasetcs
New Member
July 19, 2018
Solved

SD WAN help

  • July 19, 2018
  • 1 reply
  • 2578 views

I have a fortigate 60e with 2 WAN lines coming in so I setup SD WAN with 50% volume on each and then set a SD-WAN status check and it shows as both WANs up. Then I changed my IPv4 policy instead of it been WAN1 to SD-WAN but now the internet wont work.

 

ANny ideas whats wrong ive followed guides but doesnt seeem to work oddly. Is there a step I've missed?

 

Switched back to just using 1 WAN for now but really wnat 2 so we have a fail safe if one goes down.

    Best answer by AQArquetiponet

    Did you add an static route to 0.0.0.0/0 using sdwan interface?

    1 reply

    AQArquetiponet
    AQArquetiponetAnswer
    New Member
    July 19, 2018

    Did you add an static route to 0.0.0.0/0 using sdwan interface?

    Terms & ConditionsAccessibility statement