Skip to main content
HS08
HS08
Contributor III
September 16, 2026
Solved

RADIUS not enabled

  • September 16, 2026
  • 4 replies
  • 67 views

I have 2 cisco switch managed by fnac and i add the 3rd cisco switch.

After i configure the dot1x on the 3rd switch then the authentication is rejected with below error

What mean of RADIUS not enabled on device? IN the inventory the RADIUS was enabled.

 

Best answer by ebilcari

As discussed in the other post: 

 

4 replies

caunon
Staff
caunon
Staff
September 17, 2026

Kindly ensure that the configuration selectors are configured correctly in FortiNAC.For detailed instructions, please refer to the following the link as following. 

https://docs.fortinet.com/document/fortinac-f/7.6.7/support-for-radius-only-devices/418014/step-6-create-configuration-selectors

 

    HS08
    HS08Author
    Contributor III
    September 17, 2026

    Existing cisco device is not use any configuration selectors

    ebilcari
    Staff
    ebilcariAnswer
    Staff
    September 17, 2026

    As discussed in the other post: 

     

    Emirjon
      Terms & ConditionsAccessibility statement