Monitor Interfaces for High Availability devices question

3 replies
2716 views

Dear All,

I have 2 x fortigate 201F with HA, port 23 & 24 were connected to each other for HA, may i ask for monitor interfaces which interface i should be added for this ? does it means if i added a interface for example port3, if this port3 were disconnected, the whole devices will be failover to the secondary device ? any help would be appreicated

piaakit

smaruvalaAnswer

Staff

Hi,

- You should be monitoring the interface which are connected and passing the critical traffic in your network. Please refer the below document.

https://community.fortinet.com/t5/FortiGate/Technical-Tip-Best-Practices-for-Interface-monitoring-port/ta-p/190138

Regards,

Shiva

smaruvalaAnswer

Staff

Hi,

- You should be monitoring the interface which are connected and passing the critical traffic in your network. Please refer the below document.

https://community.fortinet.com/t5/FortiGate/Technical-Tip-Best-Practices-for-Interface-monitoring-port/ta-p/190138

Regards,

Shiva

piaakit1210Author

New Member

as the current HA devices already configured sd wan with 2 circuits with load balancing, if i enable monitoring interfaces, does it means they have the same result to failover internet circuit

Hong_FTNT

Staff & Editor

Hi @piaakit1210,

If Monitor interface is down, it will trigger HA failover.

Regards,

Sign up

Login with SSO

Login to the community

Login with SSO