IPsec VPN WAN2

Hi,

Would like to ask some help regarding IPsec VPN setup using wan2. 1 site is behind NAT and the other is facing public.

Scenario:

Main - Wan1 behind NAT and admin network uses for internet.

Wan2 will be use for IPsec VPN to branch

Branch - Wan1 behind NAT and admin network

Issue, i cannot seems to enable Main Wan2 facing public. Where can i set the gateway for this wan2 if it is in manual mode?

Default route is already set for network to use Wan1 for internet.

Regards.

New Member

Hi Everyone,

Just an update. I was able establish the site to site vpn using the wan1. Both are behind NAT. The issue now is i cannot access the branch host.

Main Lan Interface ip is different subnet from host ip behind the fortigate.

Branch Lan interface ip is same subnet with host behind it.

Main - Routing is handled by a different server. on which i have already added the routing config.

I think im missing something here.

Hope someone helps.

Thank you

Sign up