Skip to main content
zaidhashem
zaidhashem
New Member
August 23, 2021
Question

High Availability between 2 FG200 connected to 2 WAN same ISP

  • August 23, 2021
  • 1 reply
  • 4064 views

Hello 

We have internet stability issue with below setup same as attached:

- 2x FG200 in HA a/a mode connected directly to 2X routers on same ISP

- 2X PTP private subnets primary and secondary on X1 ( WAN ports )

- 2X default routes towards the 2x gateway sides 

- DNAT one to one for internal servers 

- Source overload NAT for servers to reach the internet 

 

The issue is internet and reachability flaps on internal servers when the slave unit is up.

I tried to set high preference on primary default routes and routing table is ok !!

 

The objective is have load balance on both WAN, so any advice on the proper setup from FG side or ISP side, I don't want to put sw in between.

  

1 reply

lobstercreed
lobstercreed
New Member
August 23, 2021

zaidhashem wrote:

so any advice on the proper setup from FG side or ISP side, I don't want to put sw in between.

 

Well, you've contradicted yourself here.  The proper setup IS to put a switch in between.  For HA to work the logical and physical connectivity must be identical on all sides of both firewalls.  Otherwise you might as well make them standalone with routing protocols between them to handle the load sharing.

zaid
zaid
New Member
August 24, 2021

Adding switch is single point of failure so we need extra 2 switches.

As per my checking the issue is related to the route back from 2nd router get dropped at the 2nd FG unit, so to solve this the ISP should configure HSRP from their side with cross connections FG to Routers to have reachability between all nodes.

Or connect the cluster to one router only. 

I think this two setups are much easy to go with.

 

 

 

 

lobstercreed
lobstercreed
New Member
August 24, 2021

After dropping how many thousands on hardware you don't want to spend $40 to go with a supported, by the book, configuration?

https://www.amazon.com/dp/B07PJ7XZ7X/ref=emc_b_5_t 

 

https://docs.fortinet.com/document/fortigate/6.2.9/cookbook/357558/ha-active-active-cluster-setup 

 

 

You would get more throughput making them standalone firewalls with a dynamic routing topology anyway though, as active-active doesn't give much more performance than active-passive in most circumstances.  HA just gives you hitless failover, which it sounds like isn't very important to you.

 

Terms & ConditionsAccessibility statement