Skip to main content
Robbo009
Robbo009
New Member
April 16, 2019
Question

Hard disk dead FA100B

  • April 16, 2019
  • 1 reply
  • 4926 views

Hi all,

I've a FortiAnalyzer 100 and the hard disk is dead. Could someone tell me the process to change the dead drive for a new one? Does it need to be the same size? Or can it be smaller?

 

The error I have on the FA is here. I've tried check and rebuild it but nothing. 

 

FL100B (15:23-06.06.2006)

Ver:04000005

Serial number:xxxxxxxxxxxxx

RAM activation

Total RAM: 512MB

Enabling cache...Done.

Scanning PCI bus...Done.

Allocating PCI resources...Done.

Enabling PCI resources...Done.

Zeroing IRQ settings...Done.

Verifying PIRQ tables...Done.

Disabling local APIC...Done.

Boot up, boot device capacity: 122MB.

Press any key to display configuration menu...

......

 

Reading boot image 1767738 bytes.

Initializing FortiAnalyzer...microcode: no support for this CPU vendor

 

No disks available

Mounting log filesystem ... 

Could not mount log filesystem, system may not work properly.

Formating logdisk ... 

mount_all:96 Format logdisk error

>> The log disk is not mounted.

>> Booting in Maintenance mode.

 

 

Regards,

Rob

    1 reply

    Robbo009
    Robbo009Author
    New Member
    May 16, 2019

    Anyone help out here ? Much appreciated.

    rwpatterson
    rwpatterson
    New Member
    May 16, 2019

    Have you tried removing and reinstalling that drive? That may buy you some time.

    Robbo009
    Robbo009Author
    New Member
    May 16, 2019

    Thanks for the reply. I was going to but my question is does the drive need to be the same size? Or can it be smaller than the original? Once the new drive is installed what commands do I need to run to prepare the drive?

    Cheers,

    Rob

    Terms & ConditionsAccessibility statement