FortiManager Interface View

Forum|Forum|2 years ago
July 18, 2024
3 replies
2438 views

Hello everyone,

We have recently started using a FortiManager VM (v7.4.3-build2487 240514 (GA)). We use it to manage a Fortigate 400F and of course also create our policies with it. Now to my problem: I have not been able to change the view mode for a few days and am now stuck in ‘By Sequence’ mode, the button for this has disappeared. According to a Fortinet article, the reason for this is that there are two interfaces in From or To - but I have checked each of the rules and there is only 1 interface in From and To in each rule. Do you have any idea how I could correct this?

Kind regards

Marc

Best answer by jasonhong

Based on my understanding, the Section view will be disabled if one or more policies are using the Any interface, or if one or more policies are configured with multiple source or destination interfaces.

If you have confirmed that there is no policies that are configure with multiple source or destination interfaces, perhaps you can check on whether if there are any policies configure to use the Any interface.

https://docs.fortinet.com/document/fortimanager/7.4.3/administration-guide/951881/managing-policies

jasonhongAnswer

Staff & Editor

Based on my understanding, the Section view will be disabled if one or more policies are using the Any interface, or if one or more policies are configured with multiple source or destination interfaces.

If you have confirmed that there is no policies that are configure with multiple source or destination interfaces, perhaps you can check on whether if there are any policies configure to use the Any interface.

https://docs.fortinet.com/document/fortimanager/7.4.3/administration-guide/951881/managing-policies