Skip to main content
moshe800
moshe800
New Member
August 27, 2018
Question

FortiGate 100E

  • August 27, 2018
  • 1 reply
  • 4023 views

Dear All,

FG100E  v5.4.4,build7650 (GA)

I setup VPN Ipsec site to site to Azure.

Ipsec monitor shown its down. on Azure end connection state: unknown.

Pre shared is correct on both ends,  any idea looking at Forti log where is the issue?

 

Date    08/27/2018 Time    05:05:33 Virtual Domain    root Log Description    Progress IPsec phase 1 Source Local IP    31.168.42.222 User     N/A Group    N/A XAUTH User    N/A XAUTH Group    N/A Action Action    negotiate Status    failure Result    ERROR Security Level     Event Assigned IP    N/A Cookies    3e35c70729dfedef/0000000000000000 Direction    inbound Local Port    500 Outgoing Interface    wan1 Remote IP    216.218.206.74 Remote Port    36121 Role    responder Stage    1 VPN Tunnel    N/A Mode    main Message    progress IPsec phase 1

    1 reply

    makco10
    makco10
    Explorer II
    October 19, 2018

    Hello,

     

    Is important that you check the config in the two sides to confirm that is not a different config of phases.

     

    -Check phases 1 and 2 settings.

    -Confirm pre-shared key

    - change to aggresive mode 

     

    In your case I think is a issue with the phases, so review the settings and confirm that you don´t have a mismatch configuration.

     

    Regards.

     

    Terms & ConditionsAccessibility statement