Skip to main content
Marcos_FDS1012
Marcos_FDS1012
New Member
April 23, 2025
Solved

Deleting an Interface

  • April 23, 2025
  • 1 reply
  • 993 views

I need to delete ima Interface, but I can't figure out how to do it? I want to remove it and put it in SEM_USO

 

Interface.png

Best answer by funkylicious

it should be available for being part of the hardware switch.

have you tried editing the HW SW and adding it ? its not available for selection ?

1 reply

funkylicious
SuperUser
funkylicious
SuperUser
April 23, 2025

hi,

you cannot delete a built-in/default interface.

what is SEM_USO where you want to put it or what do you actually want to do with it ? as long as there's no IP configured on it and has 0 references, you can basically use it for whatever you want to configure on the FortiGate.

"jack of all trades, master of none"
    Marcos_FDS1012
    Marcos_FDS1012Author
    New Member
    April 23, 2025

    I don't think I've explained the director I want to remove Physical Interface where it's yellow and put Hardware Switch where it's green.

     

     

    Remover.png

    funkylicious
    SuperUser
    funkyliciousAnswer
    SuperUser
    April 23, 2025

    it should be available for being part of the hardware switch.

    have you tried editing the HW SW and adding it ? its not available for selection ?

    "jack of all trades, master of none"
      Terms & ConditionsAccessibility statement