Skip to main content
aagrafi
aagrafi
New Member
December 15, 2017
Solved

CLI to set log severity level

  • December 15, 2017
  • 1 reply
  • 16317 views

Hello,

Can somebody remind me the CLI to set the log severity level in a FG unit? The handbook clearly states that:

"The log severity level is defined by you when configuring the logging location", but it doesn't say how (not the first time, actually...)

Thanks

    Best answer by Toshi_Esumi

    It's either, or both, under "config log syslogd/fortianalyzer filter". I don't know this is common through all models but I see 4 servers we can configure. Then you can do "set severity" at each server config.

    1 reply

    Toshi_Esumi
    SuperUser
    Toshi_EsumiAnswer
    SuperUser
    December 15, 2017

    It's either, or both, under "config log syslogd/fortianalyzer filter". I don't know this is common through all models but I see 4 servers we can configure. Then you can do "set severity" at each server config.

    sekar_karthi
    sekar_karthi
    New Member
    February 12, 2021

    FW (global) # config log syslogd2 filter FW (filter) # get severity            : information forward-traffic     : enable local-traffic       : enable multicast-traffic   : enable sniffer-traffic     : enable anomaly             : enable voip                : enable dns                 : enable ssh                 : enable filter              : filter-type         : include FW (filter) # set severity emergency       Emergency level. alert           Alert level. critical        Critical level. error           Error level. warning         Warning level. notification    Notification level. information     Information level. debug           Debug level.

    Terms & ConditionsAccessibility statement