Skip to main content
shafnas
shafnas
New Member
February 12, 2019
Solved

Adding Lease line

  • February 12, 2019
  • 1 reply
  • 6395 views

Hi All,

We are using Fortinet 300E and another for fail over, i just want to know how to add a lease line which we bought only for to access a application from outside but it should not effect the current setup or effecting our LAn or WAN.

We already have two line.

 

Please help.

    Best answer by Toshi_Esumi

    If you set up HA between two FGTs, the best option to "share" circuits is to terminate the physical circuits at a switch then tug the packets with vlans and span them toward both units through the ports connected to them. 

    1 reply

    Toshi_Esumi
    SuperUser
    Toshi_EsumiAnswer
    SuperUser
    February 12, 2019

    If you set up HA between two FGTs, the best option to "share" circuits is to terminate the physical circuits at a switch then tug the packets with vlans and span them toward both units through the ports connected to them. 

    lobstercreed
    lobstercreed
    New Member
    February 13, 2019

    Shafnas,

     

    If I'm reading your post correctly, you want to understand how to configure something to be accessible via this special WAN connection only. 

     

    Where is the application that you want to make accessible?  Is it in your LAN, or can it be on its own interface connected to the firewall? 

     

    It sounds like you're going to need to do some policy-based routing to get it to send packets back out on this special WAN if normally it goes out your current WAN.  It might not even be possible depending on who all needs to access it or what it needs to be able to access...

     

    - Daniel

      shafnas
      shafnasAuthor
      New Member
      February 14, 2019

      planning to configure in LAN port.

      Terms & ConditionsAccessibility statement