Meru Technical Note - Wireless client moved to wired side
Description
Scope
Solution
Wireless client moved to wired side.
Scope
KB ARTICLE TYPE: Troubleshooting
RELATED PRODUCTS: NA
RELATED SOFTWARE VERSIONS: All versions
KEYWORDS: G1 G2 interfaces
Solution
The error "Client moved to wired side" appears when there is a network loop.This may be observed when the controller is configured for dual bonding. The second interface configured for guest network is connected to the same switch. G1 and G2 interfaces are connected to the same switch. The client, who connects to the wireless network will appear in wired side in two minutes.
Note: The recommended configuration for G2 is to connect this interface for external network. Make sure these ports are not going to connect each other.