Meru Technical Note - Changing the admin password on the Network Manager

Changing the admin password on the Network Manager

KB Article Type: Configuration

Related Products: EzRF

Related Software Versions: All software version.

Keywords: admin, EzRF, password

Commands to change the network manager ( EzRF ) password for the user "admin"

CLI CONFIGURATION STEPS:

Step 1 : Type "configure terminal"

Step 2 : Type "passwd admin"

Step 3 : At the prompt, enter the new password for admin. At the next prompt, retype this password for it to be confirmed and stored for future logins.

Step 4 : Type "exit" to return to the privileged exec mode.

Case 1: After entering the password the first time, if the next line reads "BAD PASSWORD: it is too short..", this does not mean it has rejected the password, it is merely a caution message. Proceed to confirm this password by re-entering it.

Case 2: After entering the password in re-type the password, if the next line read " Sorry, password doesn't match". please make sure the password entered first and password entered in re-type password match. This error is caused since the password didn't match.