| By default, the sh file type is not available under DLP. In this case, it is possible to create a pattern and apply in the DLP sensor. Also, note that it would require deep inspection. config dlp dictionary edit "Test-Dictionary" set uuid fff805ca-8607-51ee-d5d5-84e013c472f2 config entries edit 1 set type "regex" set pattern "\\/bin\\/bash*." next end end config dlp sensor edit "test" config entries edit 1 set dictionary "Test-Dictionary" next end next end config dlp profile edit "Block sh" set feature-set proxy config rule edit 1 set name "Block sh" set severity critical set proto smtp pop3 imap http-get http-post ftp nntp mapi ssh cifs set filter-by sensor set file-type 3 set sensor "test" set action block next end next end config firewall policy edit 2 set status enable set name "Default rule" set uuid f28e5370-885b-51ee-1df4-dc30ae3a156d set srcintf "port1" set dstintf "port2" set action accept set srcaddr "all" set dstaddr "all" set schedule "always" set service "ALL" set utm-status enable set inspection-mode proxy set ssl-ssh-profile "custom-deep-inspection" set dlp-profile "Block sh" set logtraffic all set nat enable next end Related article: Technical Tip: DLP Configuration to Block File's and Troubleshooting |