Technical Tip: SNMP error OID not increasing

Use the FortiGates CLI to display the interface configuration:

        #show system interface

Depending on the number of interfaces it can be difficult to spot the interfaces which are causing the problem.

Use the following command to only print the snmp-indexes:

        #show system interface | grep snmp-index

Sample output

        FGVM02 #show system interface | grep snmp-index 

In this example the snmp-index 3 appears twice.

To identify on which interfaces the duplicate snmp-index is configured, the following command will show the complete configuration part:

        #show system interface | grep -f ‘snmp-index 3’

Sample output

        #config system interface

            edit "port3"
                set vdom "root"
                set ip 10.191.248.17 255.255.255.224
                set allowaccess ping https ssh snmp http
                set type physical
                set snmp-index 3 <----
            next
            edit "port4"
                set vdom "root"
                set ip 10.191.7.25 255.255.255.0
                set allowaccess ping
                set type physical
                set snmp-index 3 <----
            next
        end

Change the snmp-index to an unused integer value to resolve the problem:

        #config system interface

           edit <port>   

       set snmp-index <integer>

end