Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
Shagma
New Contributor

Limited CLI commands available

Yesterday I was at a customer who had a transparent setup for UTM filtering.

I am not very familiar with transparent configurations, but the FGTs only had a few commands available to be run. For instance, 'diagnose' and 'get test' amongst others, were not available.

 

What could be the cause of this? They were running FW 5.2.4 on two 310Bs in HA. The admin account had super_admin rights.

 

Another question: A previous administrator had activated Web-Filtering on an inbound rule. What can be achieved from this? I don't understand how that would work.

1 Solution
Jupiter_FTNT
Staff
Staff

you need to go inside vdom  or  global to access the full CLI if the FGT has vdom enable.

View solution in original post

3 REPLIES 3
Jupiter_FTNT
Staff
Staff

you need to go inside vdom  or  global to access the full CLI if the FGT has vdom enable.

Shagma

Jupiter_FTNT wrote:

you need to go inside vdom  or  global to access the full CLI if the FGT has vdom enable.

I am unfamiliar with VDOM operation.

 

Is this accomplished by:

config vdom

edit vdom_name

 

Or is there a separate root vdom management IP?

emnoc
Esteemed Contributor III

1st you need to determine if your running vdoms to begin with, but a get system statsus should full-fill that purpose.

 

(e.g  abbr output )

 

Virtual domains status: 2 in NAT mode, 4 in TP mode Virtual domain configuration: enable

 

 

2nd,

 

What could be the cause of this? They were running FW 5.2.4 on two 310Bs in HA. The admin account had super_admin rights.  

 

That doesn't mean to  much, what rigths permissions does the  "super_admin"  profile have? Was it changed to remove Read/Write access? ( basically look at the permissions in that account )

 

3rd

 

Another question: A previous administrator had activated Web-Filtering on an inbound rule. What can be achieved from this? I don't understand how that would work.

 

Maybe it's a typo or incorrect policy or traffic is indeed using this rule in another direction. You can enable logging and monitor the rule for activity over the course of 1-2 weeks and see if anything matches it.

 

IMHO: If your taking over an existing network, it's probably best to re-audit ALL rules for dupes, and poor rules or sequences.

 

PCNSE 

NSE 

StrongSwan  

PCNSE NSE StrongSwan
Announcements

Select Forum Responses to become Knowledge Articles!

Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.

Labels
Top Kudoed Authors