I am trying to configure the fortiportal with a secondary IP address and every time I do so, I get the error
"Disabling interface eth1"
after I enter the end command
here is what I input:
fortiportal # conf system interface
(interface)# edit port2
(port2)# set ip (ip address and subnet)
The system already has a primary address and port1 configured with an ip which we use to access through ssh to configure the secondary ip.
What we are trying to do is have a primary IP for one team to use for configuration and a secondary for another to access Fortiportal.
Did anyone have any luck in configuring two IP addresses for Fortiportal?
Solved! Go to Solution.
Hi @efernandes ,
Are you able to enable the port2 first? By right it will automatically enabled after you enter the IP (x.x.x.x/xx)
fortiportal # config system interface
(interface)# edit port2
(port2)# set status enable
(port2)# end
Hi @efernandes ,
Are you able to enable the port2 first? By right it will automatically enabled after you enter the IP (x.x.x.x/xx)
fortiportal # config system interface
(interface)# edit port2
(port2)# set status enable
(port2)# end
thank you this worked
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.