Fortigate Azure and Zones

1mm · ‎10-20-2023

Hello,

We have deployed Fortigate in Azure environment. In azure Fortigate has just 2 Interface (1 WAN, 2 LAN).

We would like to use zone for Policy. We already have several zones and use them for policy (For example VPN zones). We would like to apply zone also to LAN interface and just want to be sure that noting will be affected during this procedure (of course if there is no any misconfigurations). Are there any coveats from azure side for Azure-fortigate?

lgupta · ‎10-22-2023

Hello 1mm,

Thank you for reaching out.

You can put the LAN interface into a new Zone. You don't need to change anything on the Azure side as it is a local setting used only for reference/calling purposes in the FortiGate.

Thank you so much.

Best regards,

-lgupta

If you feel the above steps helped to resolve the issue mark the reply as solved so that other customers can get it easily while searching on similar scenarios.

View solution in original post

lgupta · ‎10-22-2023

Hello 1mm,

Thank you for reaching out.

You can put the LAN interface into a new Zone. You don't need to change anything on the Azure side as it is a local setting used only for reference/calling purposes in the FortiGate.

Thank you so much.

Best regards,

-lgupta

If you feel the above steps helped to resolve the issue mark the reply as solved so that other customers can get it easily while searching on similar scenarios.