Description This article describes how to modify route preference using
Local-Preference Attribute in BGP. Scope FortiOS. Solution Local Peer:
10.9.26.94 configurations: On this FortiGate, there are two BGP peers:
10.9.17.42 and 10.9.26.163. get rout...
Description This article explains why FortiGate replies 'Telnet to local
telnet server is not allowed' when trying Telnet to an IP. Scope
FortiGate. Solution Example Output: FGT-61E # exe telnet 192.168.100.1
443 Telnet to local telnet server is not ...
Description This article describes how to obtain the WAN IP from the
FortiGate CLI. Scope All versions of FortiOS. Solution Run the following
command in the CLI: diagnose system wan ip This will grab the public IP
of the default connection from https...
Description This article describes the configuration requirements on
FortiGate to connect the FortiSwitch to FortiGate's physical interface
and manage it. Scope FortiGate. Solution Create a new LAG-interface and
add physical interface(s) as its membe...
Description This article describes how to modify the SSL-VPN replacement
page to redirect to other website. Scope FortiGate. Solution Note: Here
the SSL-VPN Login Page is redirected to www.google.com Do this only to
completely block the SSL VPN login...
Hello Geovantae, good day! sure enough from CLI Fortinet/windows i can
not ping those public IPs>>> please grab the output of the following
from FGT CLI: [please obfuscate sensitive details] exe ping 1.1.1.1get
router info routing-table allget router...
Hello JuanPerezLopez, Please let me know what is the FortiGate firmware
version? Here is the compatibility matrix to confirm
:https://docs.fortinet.com/document/fortiap/7.4.0/fortiap-and-fortios-compatibility-matrix/495193/fortiap-and-fortios-7-x-com...
Hello Hossam3085, FGT when working in HA-AP mode only have one device
passing traffic at a given time. So you can consider HA cluster as one
device. VRRP once configured will have one single Virtual IP that can be
used as Gateway IP. You will need to...
Hello karamjeetmultani, Thank you for reaching out.Firstly, I do not see
any physical interface as a member of "fortilink" interface. And what is
connected to port1 ? Also, if you want to connect a FortiSwitch on
physical interface port1, please remo...
Hello bl1k00, Ideally when you configure DDNS for FGT when behind a NAT
device, you should enable "Use Public IP address" on the DDNS
configuration section. Do you see your public IP when you run command:
diag sys wan ip ? Refer:
https://community.fo...