Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
RyanFItz
New Contributor

New switch does not pass traffic

Fortiwifi 90D.

 

This is driving me nuts, we want to replace a switch plugged into LAN1, fortinet is configured for a soft switch. When we plug the new switch into port 1 it does not pass any traffic, What am I missing. I see no VLANS configured and I see nothing in the old switch, its a very old 10/100 netgear that I can not see any programming inside of it. what could possibly be stopping traffic?

 

We need to plug the new switch into the old switch to get any traffic passed.

 

here is configurtion of the lan softswitch interface

 

rtr1 # show system interface lan
config system interface
 edit "lan"
 set vdom "root"
 set ip 192.168.168.1 255.255.255.0
 set allowaccess ping https ssh http fgfm capwap
 set type switch
 set alias "SterNet"
 set device-identification enable
 set role lan
 set snmp-index 7
 next
end

3 REPLIES 3
SecurityPlus
Contributor II

I’m not sure that I understand the topology and the issue you are experiencing. If you connect a computer into the FortiGate LAN1 port can the computer access the internet?
RyanFItz

We are going to go back onsite and check, this makes no sense

RyanFItz

Still couldn't get this to work, all the internal ports are configured into a softswitch bonded with the wifi.

 

A laptop works fine plugged into the port.

 

A dummy 5 port switch works fine plugged into the port.

 

A cisco SG220 will not pass traffic on the port. I broke off internal 14 from the softswitch set it up as a hardware switch then the cisco worked fine. We just left it at that and made a rule to pass the wifi and lan across each other between the softswitch and port 14

Announcements

Select Forum Responses to become Knowledge Articles!

Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.

Labels
Top Kudoed Authors