not found wan1 to add at wan-load-balance

[sfareg]

i want to configuration load-balance 

but found wan2 only

[neonbit · Accepted solution]

It's because WAN1 is already being referenced in policies, routes etc.

You need to remove all references to WAN1 before you can then add it to the wan LLB.

[neonbit · Accepted solution]

It's because WAN1 is already being referenced in policies, routes etc.

You need to remove all references to WAN1 before you can then add it to the wan LLB.

[ERNESTO_GARÍ · Accepted solution]

Greetings, you must deactivate routes, policies and objects that are associated with that interface, so that you can appear in the WLLB

[sfareg]

thanks

[fred339]

One way to preserve the policies, etc. instead of deleting them and starting over is to assign them to an unused interface.  So, if they are something like INSIDE > OUTSIDE and going to WAN1, change them to go from INSIDE > internal4 temporariliy.

Then, when WAN1 is where you want it, you can change them back.  

Easier to preserve things this way....