I've upgraded some of my devices to 6.2.1 recently and tested the SD-WAN
feature and ran into a funny issue with VPN's. In the SD-WAN I have four
interfaces added, two are my underlay physical interfaces (MPLS and
INTERNET) and the other two are the ...
I've recently upgraded my FG201E to 5.6.1 and for some reason devices
connecting via SSLVPN are now showing up correctly in FortiView (ie:
can't determine their OS). This was working fine in 5.6.0, where I could
see users, forticlient status and devi...
Hi guys, I've been testing out the new WLC-VM 8.3.2 Vmware image lately
and have noticed that the webgui is very slow. It's so slow that it will
usually time out when I try navigating through it. Tested on ESXi and on
VM Workstation and both are very...
I've been testing a WLC config in my lab and ran into a strange issue
regarding VLANs. I have eth1 configured with 10.1.1.1/24 and created
VLAN100 on eth2 (VLAN id:100 IP: 10.0.1.1/24 GW: 10.0.1.254). The
problem is that I can't ping VLAN100's GW (10...
I've tried to upgrade my FSA1000D to 2.4.0 and it keeps giving me an
error. Sometimes the error says that the image is wrong, sometimes it
says the partition is wrong, sometimes it gives a non descriptive error.
Confirmed the checksum of the image wa...
You can do this in the GUI, under User & Device > User Definition you
will see all the users. In the far right column there's a column called
'Ref'. Click the number next to the user to show you all the groups it's
been added to.