.

[che9992]

.

[rwpatterson]

From the CLI, find the number that DHCP scope is in and change that number in the script you are pasting in

As in "edit [old number here]"

[che9992]

.

[rwpatterson]

            config exclude-range
                edit 1
                    set end-ip 192.168.100.100
                    set start-ip 192.168.100.1
                next
            end

[che9992]

.

[rwpatterson]

Could you post the DHCP server section from the CLI here?

Another question. Are you positive there are no other DHCP servers on the subnet? One recommendation I always give is to never use the factory default subnets. (192.168.0.x/24: D-Link, 192.168.1.x/24: everyone, 192.168.2.x/24: others, etc) This creates havoc when someone introduces another factory set device onto your wire.

If you have a PC getting a lower IP address, run IPConfig /all and look for the IP address of the DHCP server. Also from the command prompt, run 'arp -a' and see what the MAC address of that device is. Make sure that it's the same as your Fortigate.

[che9992]

.

[rwpatterson]

che9992 wrote:

"sh sys dhcp server"

Connected

EDU_Sherpa $ sh sys dhcp server config system dhcp server edit 2 set dns-service default set default-gateway 192.168.1.99 set netmask 255.255.255.0 set interface "mgmt" config ip-range edit 1 set start-ip 192.168.1.110 set end-ip 192.168.1.210 next end next edit 3 set forticlient-on-net-status disable set dns-service default set default-gateway 192.168.90.99 set netmask 255.255.255.0 set interface "free"

In this piece, there is no entire class C range from 1-254 and there is no exclude.

[che335]

But im using "lan" range from 192.168.100.1-254 Should i delete "free" and "mgmt"? But i have no idea why "lan" is not in there

[rwpatterson]

DHCP server range needs to be 1-254, nut just what you want to hand out.

[che9992]

.