- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
SVI and Sub-Interface Configuration Using GUI
Q1 How do you configure a switch virtual interface and
do vlan tagging on the firewall ports using GUI?
Q2 If it is possible, pls do guide me and advice if I am supposed
to use a software switch or a hardware switch?
Q3 How come there can be 3 ip addresses for the physical
and virtual interfaces? Ip addresses should only be on the physical
or virtual interface, not both. (there are one physical and 2 virtual interfaces)
Q4 How do you configure an interface and assign sub-interfaces to it
using GUI?
Solved! Go to Solution.
- Labels:
-
FortiGate
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
A1. Again no SVI. No way with FortiGates. FGTs are not "L2/L3 switch-router".
Toshi
- « Previous
-
- 1
- 2
- Next »
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
You don't need to use software switch. Usage for software switch is in specific scenarios. For example, you want to have your LAN and SSID working as a one interface. If you want to have Vlan, you create VLAN same as in guide and then firewall policy to allow traffic between interfaces.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
A1. Again no SVI. No way with FortiGates. FGTs are not "L2/L3 switch-router".
Toshi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In the end I had to configure a physical interface with ip addres, enable dhcp and then put my own switch as the downlink to solve the issue.

- « Previous
-
- 1
- 2
- Next »