IP and Mac is synced but standalone-mgmt-vdom setting is enabled

[kjiye]

Is the expected result of the management vdom's IP and Mac syncing with the standby device when the standby device reboots even though the standalone-mgmt-vdom setting is enabled?

This is the active device's ha setting and the firmware version is 6.0.8.

config system ha set group-id 23 set group-name "giosis_korea" set mode a-p set sync-packet-balance disable set password ENC KSHNfQEYgQnPAtrgLBaPJLE+T23CbzqB9CECWOtrTM92oySSTNZ71DYhs5zcqNKzAX6e5ohKAAKmzCL2ApKi/AM9uF1w7MPhhIdvm9C3fORtFwZnWLzRfJqU1J4kPs/ny7jK6SsnbkvVwfRVcCgJhrByF8Qmg/5ufMPgX0GBoTIEk8fRbgVuL3+fMo+3MZ8w37PBjQ== set hbdev "port1" 50 "port2" 50 unset session-sync-dev set route-ttl 10 set route-wait 0 set route-hold 10 set multicast-ttl 600 set sync-config enable set encryption disable set authentication disable set hb-interval 2 set hb-lost-threshold 6 set hello-holddown 20 set gratuitous-arps enable set arps 5 set arps-interval 3 set session-pickup enable set session-pickup-connectionless disable set session-pickup-delay disable set link-failed-signal disable set uninterruptible-upgrade enable set standalone-mgmt-vdom enable set ha-mgmt-status disable set ha-eth-type "8890" set hc-eth-type "8891" set l2ep-eth-type "8893" set ha-uptime-diff-margin 1 set vcluster2 disable set override disable set priority 200 set monitor "dmz1" "dmz2" "port16" unset pingserver-monitor-interface set pingserver-failover-threshold 0 set pingserver-slave-force-reset enable set pingserver-flip-timeout 60 unset vdom set memory-compatible-mode disable set inter-cluster-session-sync disable end