Is the expected result of the management vdom's IP and Mac syncing with the standby device when the standby device reboots even though the standalone-mgmt-vdom setting is enabled?
This is the active device's ha setting and the firmware version is 6.0.8.
config system ha set group-id 23 set group-name "giosis_korea" set mode a-p set sync-packet-balance disable set password ENC KSHNfQEYgQnPAtrgLBaPJLE+T23CbzqB9CECWOtrTM92oySSTNZ71DYhs5zcqNKzAX6e5ohKAAKmzCL2ApKi/AM9uF1w7MPhhIdvm9C3fORtFwZnWLzRfJqU1J4kPs/ny7jK6SsnbkvVwfRVcCgJhrByF8Qmg/5ufMPgX0GBoTIEk8fRbgVuL3+fMo+3MZ8w37PBjQ== set hbdev "port1" 50 "port2" 50 unset session-sync-dev set route-ttl 10 set route-wait 0 set route-hold 10 set multicast-ttl 600 set sync-config enable set encryption disable set authentication disable set hb-interval 2 set hb-lost-threshold 6 set hello-holddown 20 set gratuitous-arps enable set arps 5 set arps-interval 3 set session-pickup enable set session-pickup-connectionless disable set session-pickup-delay disable set link-failed-signal disable set uninterruptible-upgrade enable set standalone-mgmt-vdom enable set ha-mgmt-status disable set ha-eth-type "8890" set hc-eth-type "8891" set l2ep-eth-type "8893" set ha-uptime-diff-margin 1 set vcluster2 disable set override disable set priority 200 set monitor "dmz1" "dmz2" "port16" unset pingserver-monitor-interface set pingserver-failover-threshold 0 set pingserver-slave-force-reset enable set pingserver-flip-timeout 60 unset vdom set memory-compatible-mode disable set inter-cluster-session-sync disable end
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1737 | |
1107 | |
752 | |
447 | |
240 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.