FortiView only shows now

[kinmun]

i noticed that my Fortiview only shows data for now.

there is no data in 5 mins, 1 hour and 24 hours.

what is the settings I need to configure ?

i have analyzer installed as well.

logs is configured to store & upload to analyzer daily at 23:59.

[YtseJam · Accepted solution]

I think you should stick with realtime settings then if you want to monitor your logs just go with your analyzer. Since you have FortiAnalyzer, let it manage the reports then for your fortigate box, let it do the firewalling. Just a suggestion. 

Regards,

Jam

[Irfan_Pathan · Accepted solution]

Hi, Upgrade your firmware to v5.2.3 See attached screenshot.

-Irfan Pathan

[YtseJam · Accepted solution]

I think you should stick with realtime settings then if you want to monitor your logs just go with your analyzer. Since you have FortiAnalyzer, let it manage the reports then for your fortigate box, let it do the firewalling. Just a suggestion. 

Regards,

Jam

[kinmun]

realtime is not selected.

have since changed to display from analyzer. it was set to disk previously.

[markwen]

Correct me if I'm wrong, but doesn't "Enable local reports" need to be enabled to view this kind of info from the FortiGate dashboard? Otherwise it won't store historical data in it's local db.

[Irfan_Pathan · Accepted solution]

Hi, Upgrade your firmware to v5.2.3 See attached screenshot.

-Irfan Pathan

[gustav_koekemoer · Accepted solution]

Hi All

I believe I have just fixed this issue. 

If you setup your Analyzer under "config log fortianalyzer setting" it seems to always take preference in Fortiview 5min,1H and 24H even if you select "disk" as the GIU view.

I moved my config to "config log fortianalyzer3 setting" and I can now view historical disk logs via Fortiview and the Analyzer is working fine.

Regards

Gus

[sagipael]

Thanks! that works!

 Ver 5.6.12

gustav.koekemoer@voxtelecom.co.za wrote:

Hi All

I believe I have just fixed this issue. 

If you setup your Analyzer under "config log fortianalyzer setting" it seems to always take preference in Fortiview 5min,1H and 24H even if you select "disk" as the GIU view.

I moved my config to "config log fortianalyzer3 setting" and I can now view historical disk logs via Fortiview and the Analyzer is working fine.

Regards

Gus

[VictorP1]

Hello, I have read and tried some of the solutions that you have mentioned but I have the problem in a Forti 100F, it still does not show me results in Fortiview web sites. Do I necessarily need to connect a Fortianalyzer to achieve this?