Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
Not applicable

Firewall Rules not working

Hi, i have a strange behaviour in firewall rules configuration

I set the Default Action to Deny...then i tried to open only what i desire...but it does not work

The FortiADC blocks all traffic

On the other end if i set the Defualt Action to Allow and then try to block a specifi port it ignores that rule and allow all

traffic

What i'm missing?

Thanks a lot

Giovanni

3 REPLIES 3
Not applicable

Hi Giovanni

My glass ball is in the repair, so you have to give me more information about your config

Do you have the rules in the right order, deny as last?

 

regards

Not applicable

Attached my configuration

Deny as default befault action...and only two permit rules for my lan (LanSupertronic) vs balanced address (ServerAT-PUB) and private address (ServerAT-VIVIANI)...because i don't know if firwall analyze traffic before balance it...

 

 

Regards

 

 

boneyard
Valued Contributor

Are your virtual servers on port2? or is that a real server network?

 

if it is virtual servers you need to keep the egress interface empty, see from the admin guide: "Note: If you want to control VS traffic through the firewall, you MUST leave the Egress Interface as default (blank). This allows VS packets to match the firewall rule."

Announcements

Select Forum Responses to become Knowledge Articles!

Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.

Labels
Top Kudoed Authors