- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
remove device and block form certain SSID's
i swore i was able to do this before, but is there a way to block a device (or even better yet all mobile devices) on a certain SSID and only allow them on the other SSID?
foritnet 100d (5.4) with 4 FP221B-v5.4. we have our guest network (which i want the mobile deivces to use) and our network side SSID, which a few people seem to seem connect to since they know the password.
thanks
brian
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If this was on 5.0.x codebase, you would create a standard DHCP server for the wifi SSID, and set the Unknown MAC Address" option to either assign or block. I am assuming it is still the same/similar option on 5.4 firmware.
NSE4/FMG-VM64/FortiAnalyzer-VM/6.0 (FWF30E/FW92D/FGT200D/FGT101E/FGT81E)/ FAP220B/221C
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If this was on 5.0.x codebase, you would create a standard DHCP server for the wifi SSID, and set the Unknown MAC Address" option to either assign or block. I am assuming it is still the same/similar option on 5.4 firmware.
NSE4/FMG-VM64/FortiAnalyzer-VM/6.0 (FWF30E/FW92D/FGT200D/FGT101E/FGT81E)/ FAP220B/221C
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
thank you, i did figure that part out after i posted - same way on 5.4 pretty much. i need to readup and see if i can block all mobile devices on a SSID from joining
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It seems the MAC address access control list option has been removed from firmware 5.2.5
