create dual wan without load balancing

[Yosef]

hi everyone i'm trying to create dual wan to work with two of them together in format that lan1 always use wan 1 and lan 2 alleys use wan 2 for different department and different secure internet so i connect the wan's to the internet and created two ipv4 policies: lan 1 > wan 1 lan 2 > wan 2 and disabled the wan balancing feature but there still a problem with connection it's seem like the computers chose the wan to use randomly and when they try to use the different wan like lan 1 to wan 2 they cannot use internet because of the policy so what can i do to resolve the problem thanks for help

[Anilmeena999 · Accepted solution]

Create policy route like.

incoming interface lan1 source address 192.168.1.0/24 destination address 0.0.0.0/0.0.0.0

outgoing interface wan1

incoming interface lan2 source address 192.168.2.0/24 destination address 0.0.0.0/0.0.0.0 outgoing interface wan2

[Yosef]

of course i did it but still lan 1 trying to get out thru wan 2 in some computers and they're cannot connect to internet

[Anilmeena999]

Assign priority in static route of wan2 greater that wan1

[Yosef]

i found my problem i created firewall policy and static route but not rote policy so i had to use cli because of my fortigate model does not have this feature it seem like this:

config router policy

edit 8  set input-device "internal1"  set output-device "wan1"  next  edit 5  set input-device "internal2"  set output-device "wan2"  next  end