- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
VPN IPsec with dh 32
Today I configured a FGT200E with an IPsec VPN with a PFsense. For the first time I used the DH32 (elliptic curve) in phase 1 (AES256, SHA256). no PFS in phase 2. Do you think we have problems with slow communication? If so, which protocols might it affect?
Thank you.
Regards.
Marco Spada
W3 - Italy
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @mspada ,
This unit FG200E, offers 7.2GBit IPSEC VPN throughput with Aes256, Sha256 algrotihm.
If you don't have much more ipsec traffic for example more than 5Gbit. I think you will not see latency problems on your ipsec traffic outside of normal ipsec latency.
https://www.fortinet.com/content/dam/fortinet/assets/data-sheets/FortiGate_200E_Series.pdf
NSE 4-5-6-7 OT Sec - ENT FW
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Ideally it should not have an impact as it is used for key exchange purposes only.
Regards,
Shiva
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @mspada ,
This unit FG200E, offers 7.2GBit IPSEC VPN throughput with Aes256, Sha256 algrotihm.
If you don't have much more ipsec traffic for example more than 5Gbit. I think you will not see latency problems on your ipsec traffic outside of normal ipsec latency.
https://www.fortinet.com/content/dam/fortinet/assets/data-sheets/FortiGate_200E_Series.pdf
NSE 4-5-6-7 OT Sec - ENT FW
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Ideally it should not have an impact as it is used for key exchange purposes only.
Regards,
Shiva
