VLAN on an SSID

[BryEarthComm]

I added a VLAN to an SSID and relaized it was in error, as i attempted to remove the VLAN from the SSID its returns and error "Input not as expected". I have removed any policies, addresses and interfaces using the vlan, with the same result.

Any help to find other reference points i may not have thought of would be a great help to remove this, thank you.

-Bry

[Toshi_Esumi · Accepted solution]

That CLI error message generally shows up when you try to remove a system default profile or something similar, which doesn't make sense for a VLAN you created. You might need to open a ticket at TAC if a reboot wouldn't change the outcome.

[Toshi_Esumi]

GUI or CLI?

[BryEarthComm]

either is fine, but I've been using GUI

[Toshi_Esumi]

With my 6.2.7 FGT in GUI, I see "Optional VLAN ID" box only with bridge mode SSID and I could add and remove it without any error. Is it where you have the VLAN?

[BryEarthComm]

The option is unable to be altered

[Toshi_Esumi]

That's not SSID config, but an existing VLAN interface config. Did you remove SSID first?

[BryEarthComm]

I am unable to remove the SSID even though there is no references to it.

[Toshi_Esumi]

You have a VLAN subinterface QVnet.83 configured on QVnet tunnel mode SSID. So you have to remove QVnet.83 vlan first. I thought it was opposite. Can you simply remove the QVnet.83 interface?

[BryEarthComm]

"Input not as expected"

I assume there is a reference linked to it that is CLI only. I am running a 124D Fortiswitch in fortilink mode, however i made sure to clear any and all references from any vlans and ports. 

[BryEarthComm]

Problem solved, I deleted the SSID that hosted the vlan, and it cleared it. Seems like i simply missed trying this first, thank you for the help.