Unable to see Advanced setting under DHCP server

[Arthur]

Hello folks,

I recently upgraded to firmware 5.2.3 (from 5.0.x) on FG-40C.

However, after the upgrade, I no longer see the Advanced option under DHCP Server (System > Network > Interface)

I am running the FG-40C ports in internal switch mode (but my understanding bot switch mode and interface mode should have the Advanced options under DHCP Server).   I have attached a screenshot to this post.

Has anyone experienced the same issue?  Any help would be much appreciated.

Many thanks.

Cheers,

Arthur

[Sylvia · Accepted solution]

Try this:

config system global

  set gui-dhcp-advanced enable

end

Sylvia

[Arthur]

Thanks heaps Sylvia, that does the trick!

I'm quite new to FortiOS.  Do you know if there is a list advanced options that needs to be manually enable via CLI?

Cheers.

[Sylvia]

Hi Arthur,

check the CLI manual (http://docs.fortinet.com/d/fortigate-fortios-5.2-cli-reference) for all "config system global --> set gui-?"

What is needed depends on your configuration and might be different for every customer.

Sylvia

[Arthur]

Got it, will look into the CLI guide. Thanks once again Sylvia!

[Allwyn_Mascarenhas]

Also if you were looking to make IP reservations, that can be done straight from the dhcp monitor by right clicking on the allotted ip-mac combination.