Fortinac fortinac apparatus joint

[Gumo]

I am trying to add a device on Fortinac, the device is being added but the cli settings are not valid.

Fortinac:9.4.4

The error I got was as follows,

Spoiler

Unable to negotiate key exchange for server host key algorithms (client: ecdsa-sha2-nistp256-cert-v01@openssh.com,ecdsa-sha2-nistp384-cert-v01@openssh.com,ecdsa-sha2-nistp521-cert-v01@openssh.com,ssh-ed25519-cert-v01@openssh.com,ssh-rsa-cert-v01@openssh.com,ssh-dss-cert-v01@openssh.com,ecdsa-sha2-nistp256,ecdsa-sha2-nistp384,ecdsa-sha2-nistp521,ssh-ed25519,ssh-rsa,ssh-dss / server: rsa-sha2-512,rsa-sha2-256)

[AEK]

As per my experience when adding a new device, FortiNAC accepts all HK algorithms, even the obsolete ones.

• So from where are you getting this error message? Is it when you try access the device from FortiNAC CLI?
• Does the device accept ssh access from any client, or only from some clients that have a signed certificate from some CA?

[Gumo]

I don't have problems with newly added devices, I have problems with devices on Nac. When I look at the event logs of the device on Nac, I see the error message. I can access the devices I receive error messages from via cli.

[CharlesYoung]

Thank you so much for your help.

[Hatibi]

Hi Gumo,

can you try to apply the ssh KexAlgorithms as noted in this article:

https://community.fortinet.com/t5/FortiNAC/Troubleshooting-Tip-Modify-SSH-authentication-algorithms-...

If there are still issues you might need to open a TAC case and check with debugging enabled.

Enable in FNAC cli:

logs

Device -ip X.X.X.X -setAttr -name DEBUG -value "ForwardingInterface TelnetServer"  <----- Replace X.X.X.X with the actual IP. 

nacdebug -logger org.apache.sshd -level FINEST

tf output.master

After enabling this then Click "Validate Credentials" on GUI. When finished enter Ctrl+c to stop the output.

Save the logs in a text file.

Stop debbugging:

Device -ip X.X.X.X -delAttr -name DEBUG

nacdebug -logger org.apache.sshd

Attach the logs to Forticare Ticket for further inspection.

Regards

[ndumaj]

hello @Gumo 

What is the device that you are trying to add?
Is that a SW or FW?

Enable debug should provide more info.

however try via FNAC cli:
>ssh username@<ip of the device>

BR