Hi,
I have a problem creating a VPN tunnel between Fortigate90D to Check Point NGX R75 IPSEC.
The parameters between the two firewalls are the same but goes wrong.
I attach a screen shot. The LOG does not say much about the error so I do not have much information to provide you....
Thanks a lot to everyone
Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
You can run "IKE" application debug described below to see what Phase1 parameters the FGT is receiving and what it's seeing as a problem. We always set a filter like "diag vpn ike log-filter dst-addr4 x.x.xx" even when only one IPsec is configured to avoid "noise" from random hacking attemps in the debug output.
https://cookbook.fortinet.com/ipsec-vpn-troubleshooting/
Is it possible to have more detailed logs of vpn negotiation errors?
because the logs provided by fotigate are very few and not very detailed.
Is it possible to use a software or through shell to get more details?
Tanks
Yes. See the link that Toshi provided above. Alternatively see this fortinet video which steps through solving common tunnel faults.
Within the cli use the following commands to collect logs, often you can find the problem.
# diagnose debug disable
# di de reset
# di vpn ike log-filter dst-addr4 x.x.x.x <---- remote gateway IP address
# di de application ike -1
# di de enable
# di de di
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1673 | |
1083 | |
752 | |
446 | |
226 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.