FortiToken setup on 100F - push notices

[ChuckW]

I need some assistance with finishing up getting the FortiTokens working.   Newbie at this, so bare with me please.

I have loaded all the FortiTokens up, and see them all on the 100F.    I have created a RADIUS group in AD and can validate that the 100F is talking to the RADIUS server.

When testing, The VPN client (the free version) does prompt the test user but asks for the FortiToken number - does not push the Mobile display 6 digit code.    Then it disconnects.    

I have not done the following yet for the command line:

config system ftm-push
set server-ip XXX.XXX.XXX.XXX
set status enable
end

Where XXX.XXX.XXX.XXX is the public IP of our 100F device - correct?

Then I would need to contine to doing this:

1. Go to Network > Interfaces.
2. Edit the wan1 interface.
3. Under Administrative Access > IPv4, select FTM.
4. Click OK

Is this all I would need to do to get the FortiToken push working?

BTW - running a 100F, FW version 7.2.9

[Chandra_FTNT]

Please refer following KB:

FortiToken setup on 100F - push notices - Fortinet Community

[ChuckW]

This is a link back to this post.

[sjoshi]

Refer:-

https://community.fortinet.com/t5/FortiGate/Technical-Tip-FortiToken-mobile-push-notification/ta-p/1...

https://docs.fortinet.com/document/fortigate/7.6.1/administration-guide/927108/fortitoken-mobile-pus...

[ChuckW]

I keep hitting this error message:

Command parse error before 'proxy'
Command fail. Return code -61

[sjoshi]

can you let me know you get this error doing what config?

Can you share the snap of the error where you are getting?

[ChuckW]

FGT100F $ config system ftm-push

FGT100F (ftm-push) $ set proxy disable

command parse error before 'proxy'
Command fail. Return code -61

FGT100F (ftm-push) $ set server-port 4433

FGT100F (ftm-push) $ set server xxx.xxx.xxx.xxx

FGT100F (ftm-push) $ set status enable

FGT100F (ftm-push) $ end