Hi there!
I'm having some difficulties updating the firmware on a 60F unit.
I have a cluster of two, one of then (secondary) passed the upgrade with no issues (6.4.9 to 7.0.6), but the primary is giving me the error "Image upgrade failed. Firmware image is not valid".
I tried through web ui, I downloaded the image file and tried manually, and also tried though the Fortigate Cloud, with no success.
Any suggestions?
Thank you.
Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
If that consistent, one side doesn't have any problem, which the other side never succeed, I would suspect something to do with the hardware, or state of hardware.
I would definitely open a ticket at TAC to get it examined.
Toshi
Thank you @Toshi_Esumi for you answer.
Could be the checksum difference between the units after the secondary update?
Are you saying they were not in sync before start upgrading the cluster? I would fix the sync problem before starting the upgrade.
But I don't think that would cause "image not valid".
Toshi
Created on 07-20-2022 04:40 PM Edited on 07-20-2022 04:40 PM
Good Day,
Thank you for using the Community Forum.
Please make sure to backup your current config file.
Please download the following upgrade file from support.fortinet.com on your desktop. Click on [Update] beside Firmware version under System Information widget when you click on Dashboard in GUI and browse to the downloaded file.
Kindly check if the HA status are in sync under System-->HA
The cluster units can see each other?
How the Heartbeat interface connected? If is there any switch in between?
If the HA is out of sync , kindly do the following during the maintenance window to fix the sync issue :
For the synch issue with your ha cluster, the most reliable way to make sure everything syncs back together is the following.
disconnect the secondary unit (all wires)
perform a factory reset (exe factoryreset)
Backup config file from master
restore the config from the primary unit on the secondary.
from the cli, change the hostname
config system global
set hostname xxxxxx
end
change ha priority lower than the master
config system ha
set priority xxx
end
shutdown the unit
exe shutdown
re-attach ha heartbeat cables only
turn on the device and wait 5 minutes.
re-attach remaining cables.
This will ensure the proper config file is on both devices and they will sync. It will also ensure no network disruptions.
Kindly let me know, how it goes.
Thanks,
Feroz
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1712 | |
1093 | |
752 | |
447 | |
231 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.